Forums » Help »

Nexenta QLogic 4 port Fiber Card Multipath

Added by Joseph Hardeman about 1 year ago

Greetings,

I have been searching but have not found how to configure Multipathing in Nexenta so that the disks from an array connected via a QLogic 4 Port Fiber Card are seen as a single path/disk and not 4 different disks. I am able to do this with CentOS/Ubuntu by editing the /etc/multipath.conf file but I have not found how to do it here. Any suggestions or advice would be greatly appreciated.

Thanks

mrpepik


Replies

RE: Nexenta QLogic 4 port Fiber Card Multipath - Added by Linda Kateley about 1 year ago

most of the mp sets up on it's own...

but here is some info that may help

http://gdesaboyina.wordpress.com/2009/04/01/enabling-device-multipathing-using-solaris-native-mpxio/

RE: Nexenta QLogic 4 port Fiber Card Multipath - Added by Joseph Hardeman about 1 year ago

Hi Linda,

I will take a look and check it out. I was hoping the web interface would have a place to help with setting that up, but I guess the MP has to be done via CLI. Just wanted to make sure I wasn't missing something there. :-)

Thanks for the link