Problem installing 3.1.3
Cannot seem to upgrade to the new version. Repository issue? upgrading from 3.1.2 is there a way to upgrade offline?
nmc@nx-1:/$ setup appliance upgrade Cleanup upgrade caches (note: cleanup is generally not required and can be skipped in most cases; if you say Yes, prepare to wait for software upgrade to complete a bit longer) ? Yes This operation may take some time to check with the remote appliance's software repository. Proceed? Yes Checking repository sources. Please wait... Found new upgrades! Verifying upgrades... Trying to gain exclusive access to the appliance. This operation may take up to 30 seconds to complete. Please wait... Exclusive access granted. Initiating appliance upgrade procedure. Please wait... Success. This upgrade will download approximately 76.40MB This upgrade will require REBOOT. Proceed? (y/n) Downloading upgrades. This may take a few minutes. Please wait... ^CCould not download all needed packages. Check failed.
Replies
RE: Problem installing 3.1.3 - Added by Roman Strashkin 11 months ago
Please try to run upgrade with '-v' option.
RE: Problem installing 3.1.3 - Added by Scott Thomas 11 months ago
Interesting. When I tried to upgrade, I got this message "Cannot Upgrade Appliance via NMV Ajax Console. Hint: Try SSH or Console login". I tried the SSH, but that doesn't find the 'setup' command, and I'm not sure what it means by 'console'. That's what I clicked that brought up the ajaxterm.
RE: Problem installing 3.1.3 - Added by Roman Strashkin 11 months ago
To upgrade Appliance you need to use NMC.
- connect to Apliance as 'root' via ssh
- connect to Appliance as 'admin' via ssh and next 'su -c nmc'
RE: Problem installing 3.1.3 - Added by Scott Thomas 11 months ago
I tried using the commands you gave me, but got the same response as TZ Ka until I used the -v switch. I got a different error, so I rebooted and tried again. Second time worked just fine! Thanks!
RE: Problem installing 3.1.3 - Added by Steven Rodenburg 11 months ago
I got the "Could not download all needed packages. Check failed" too. It worked when i retried the upgrade a couple of minutes later. Running 3.1.3 now.